OPERATORS MANUALW20RW10BTWL83W10BT BODY-PACK TRANSMITTERW20R RECEIVERWL83 LAVALIER MICROPHONE
SETTING GAIN LEVELSWith the system in place and connected, all units cannow be turned on and the levels set to their optimumpositions.TRANSMITTERPlace
CHECKLIST/OPERATIONCHECKLISTThe following checklist shows the status of yourwireless microphone system at this point. If the follow-ing steps have bee
SPECIFICATIONSSYSTEMRF Carrier Frequency150 to 216 MHz (10 frequencies between 167.875 and183.0 MHz offered; others available)Frequency Stability0.005
ANTENNASTRANSMITTERThe transmitter antenna is a permanently attached,flexible wire, 1/4-wave antenna. It has an omnidirectionaltransmission pattern (e
BATTERIESCareful transmitter battery selection, installation, useand care will help avoid problems in wirelessmicrophone use. The most dependable, lon
TROUBLESHOOTINGIf you encounter any problems in the operation of your Shure Wireless Microphone System, first make certainyou’ve followed the ABC’s of
ACCESSORIESThe following Shure Wireless System accessories areavailable through your Shure dealer. (Replacement partscan be ordered from Shure’s Servi
FCC CERTIFICATIONThe Shure Model W10BT transmitter is Type-Acceptedquency. Shure strongly urges the user to contact the ap-under Federal Communication
222 HARTREY AVENUE, EVANSTON, ILLINOIS 60202-3696 U.S.A. l TELEPHONE: (312)866-2200 l CABLE: SHUREMlCROCopyright 1986, Shure Brothers Inc.27A2314 (FL)
. . .ON ACQUIRING ONE OF THE FINEST WIRELESS MICROPHONE SYSTEMS AVAILABLE TODAY. DESIGNED FORSIMPLE SETUP AND RELIABLE OPERATION, THIS SYSTEM SHOULD P
THE WIRELESS MICROPHONE . . . what it is, what it does . . .The wireless microphone is actually a system consist-ing of a microphone, a transmitter, a
through the use of linear-phase IF filtering and high-quality audio circuitry. A high signal-to-noise ratio andwide dynamic range are necessary for no
W10BT TRANSMITTERANTENNA: This is a flexible, 1/4-wave verticallypolarized antenna approximately 30 cm (12 in.) in lengthand permanently attached to t
W20R RECEIVERFRONT PANELPOWER Push-Button Switch: Applies power from theexternal power converter or other well-filtered 13.5 Vdc(200 mA) sources to th
tion to the 1/4-wave vertical antenna supplied with theW20R (or the optional WA250 5/8-wave antenna, whichprovides up to 3 dB additional RF gain). If
SETUP AND CONNECTIONSUNPACKINGUnpack all units and parts of the Wireless MicrophoneSystem. If possible, retain packaging in the event ofreturning a un
below 7.25 volts and the battery should be replaced orrecharged (nicad only).If the battery is tested periodically, the failure of theLED to light ind
Kommentare zu diesen Handbüchern