Shure WL83 Spezifikationen PDF herunterladen (Seite 2)

W10BT TRANSMITTER

FIGURE 1

adapter cable with a 1/4-in. phone plug on the equipment

end (WA300).

MICROPHONE LEVEL Rotary Control: In conjunction

with the Gain Hi/Lo switch, this control provides addi-

tional audio level adjustment. A small screwdriver is

supplied to make adjustments.

MICROPHONE ON/OFF Toggle Switch: Permits the

user to “mute” the microphone without turning the

transmitter off. This avoids the “pop” that may accom-

pany power turn-on and turn-off, and generally prevents

pickup of unwanted signals by the receiver.

POWER ON/OFF Slide Switch: Applies power to the

transmitter circuitry. The switch is a low-profile type to

minimize accidental turn-off.

SETUP AND CONNECTIONS

With the transmitter POWER ON/OFF Switch in the

OFF position, slide the battery compartment access

cover down and off the transmitter case. Insert a new

9-volt transistor-radio-type battery (Duracell MN1604 or

equivalent) in the compartment. Observe the proper

polarity: the large (negative) terminal in the large chan-

nel and the small (positive) terminal in the small channel.

Operation with a full charged, heavy-duty, 8.4-volt nickel-

cadmium rechargeable battery is also permissible.

IMPORTANT: Do not use a “conventional” g-volt-sized

nickel-cadmium battery; its 7.2-volt output will operate

the transmitter for about 15 minutes. Carbon-zinc bat-

teries will also result in diminished operating life (about

1 hour).

Microphone Connections

The Shure WL83 lavalier condenser microphone or

similar microphones with identical wiring and a Switch-

craft TA4F type connector can be plugged directly into

the transmitter microphone jack. The WL83 will operate

using the transmitter’s regulated +5 Vdc available on

pin 2 (see Figure 2). Self-powered (battery) condenser

microphones can be used with the transmitter on/y if

they can be operated in an unbalanced mode (one side

grounded). Other non-self-powered condenser

microphones may require special wiring; contact

Shure’s Service Department for further information.

Phantom-powered condenser microphones will not

operate with the W10BT.

A high- or low-impedance dynamic or ribbon

microphone with pin 2 output can be directly connected

to the transmitter using the supplied WA310 microphone

adapter cable. The cable has a 3-socket XLR connector

TRANSMITTER CONNECTIONS AND

ACCESSORY WIRING

FIGURE 2

1 2 3 4 5

Kommentare zu diesen Handbüchern

Keine Kommentare

Shure WL83 Spezifikationen Seite 2

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikrofone Shure WL83